Hit to stop autoboot: 0 apboot> apboot> apboot> apboot> tftpboot eth0 up: 1 Gb/s full duplex DHCP broadcast 1 DHCP IP address: 10.1.37.68 DHCP subnet mask: 255.255.255.248 DHCP def gateway: 10.1.37.65 DHCP DNS server: 10.1.37.65 DHCP DNS domain: Controller address: 10.2.10.1 Using eth0 device TFTP from server 10.2.10.1; our IP address is 10.1.37.68; sending through gateway 10.1.37.65 Filename 'mips32.ari'. Load address: 0x2000000 Loading: ########################################################### done Bytes transferred = 3850268 (3ac01c hex) Image is signed; verifying checksum... passed Signer Cert OK Policy Cert OK RSA signature verified. Automatic boot of image at addr 0x02000000 ... ELF file is 32 bit Loading .text @ 0x80e00000 (3781400 bytes) Loading .data @ 0x8119b320 (32 bytes) Clearing .bss @ 0x8119b340 (16 bytes) ## Starting application at 0x80e00000 ... Uncompressing................................... ú Aruba Networks ArubaOS Version 6.1.3.7 (build 37112 / label #37112) Built by p4build@cartman on 2013-02-08 at 17:45:35 PST (gcc version 4.3.3) CPU Rev: aa 71x CPU Flash variant: default Cache parity protection disabled Using 340.000 MHz high precision timer. cycles_per_jiffy=680000 Memory: 122880k/131072k available (1850k kernel code, 8112k reserved, 693k data, 2964k init, 0k highmem) available. detected lzma initramfs initramfs: LZMA lc=3,lp=0,pb=2,dictSize=8388608,origSize=12462080 LZMA initramfs by Ming-Ching Tiew .......................................................... ............................................................................................................... ...................... AR7100 GPIOC major 0 wdt: registered with refresh Enabling Watchdog Talisker RSSI LED initialization Creating 1 MTD partitions on "ar7100-nor0": 0x00000000-0x01000000 : "flash" i2c /dev entries driver i2c-talisker: using default base 0x18040000 AD7416 driver probing for devices on AR7100 I2C .<6>lo: Disabled Privacy Extensions IPv6 over IPv4 tunneling driver Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT Starting Kernel HMAC-SHA1 KAT ...Completed Kernel HMAC-SHA1 KAT Starting Kernel DES KAT ...Completed Kernel DES KAT Starting Kernel AES KAT ...Completed Kernel AES KAT Domain Name: arubanetworks.com No panic info available Testing TPM... Passed ag7100_mod: module license 'unspecified' taints kernel. AG7100: Length per segment 512 AG7100: Max segments per packet 4 AG7100: Max tx descriptor count 400 AG7100: Max rx descriptor count 252 AG7100: fifo cfg 3 018001ff AG7100CHH: Mac address for unit 0 AG7100CHH: 00:0b:86:cf:91:bb ATHRF1: Port 0, Neg Success ATHRF1: unit 0 phy addr 0 ATHRF1: reg0 0 AP xml model 39, num_radios 2 (jiffies 4139) init_asap_mod: installation:0 radio 0: band 1 ant 0 max_ssid 8 radio 1: band 0 ant 0 max_ssid 8 setting bond0 as bridge child setting gre0 as split child Starting watchdog process... Getting an IP address... ag7100_ring_alloc Allocated 4800 at 0x8062e000 ag7100_ring_alloc Allocated 3024 at 0x813c1000 AG7100: cfg1 0xf cfg2 0x7014 ATHRF1: Port 0, Neg Success ATHRF1: unit 0 phy addr 0 ATHRF1: reg0 3100 AG7100: unit 0: phy not up carrier 1 Writing 4 ADDRCONF(NETDEV_UP): bond0: link is not ready AG7100: unit 0 phy is up...RGMii 1000Mbps full duplex AG7100: pll reg 0x18050010: 0x110000 AG7100: cfg_1: 0x1ff0000 AG7100: cfg_2: 0x3ff AG7100: cfg_3: 0x18001ff AG7100: cfg_4: 0xffff AG7100: cfg_5: 0xfffef AG7100: done cfg2 0x7215 ifctl 0x0 miictrl 0x22 ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready 10.1.37.68 255.255.255.248 10.1.37.65 Running ADP...Done. Master is 10.2.10.1 ath_hal: 0.9.17.1 (AR5416, AR9380, REGOPS_FUNC, PRIVATE_DIAG, WRITE_EEPROM, 11D) ath_rate_atheros: Copyright (c) 2001-2005 Atheros Communications, Inc, All Rights Reserved ath_rate_atheros: Aruba Networks Rate Control Algorithm ath_dfs: Version 2.0.0 Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved ath_spectrum: Version 2.0.0 Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved ath_dev: Copyright (c) 2001-2007 Atheros Communications, Inc, All Rights Reserved ath_pci: 0.9.4.5 (Atheros/multi-bss) wifi0: Base BSSID 00:0b:86:79:1b:b8, 8 available BSSID(s) bond0 address=00:0b:86:cf:91:bb br0 address=00:0b:86:cf:91:bb wifi0: AP type AP-105, radio 0, max_bssids 8 wifi0: Atheros 9280: mem=0x10010000, irq=49 hw_base=0xb0010000 wifi1: Base BSSID 00:0b:86:79:1b:b0, 8 available BSSID(s) bond0 address=00:0b:86:cf:91:bb br0 address=00:0b:86:cf:91:bb wifi1: AP type AP-105, radio 1, max_bssids 8 wifi1: Atheros 9280: mem=0x10000000, irq=48 hw_base=0xb0000000 Starting FIPS KAT ... Completed FIPS KAT shutting down watchdog process (nanny will restart it)... <<<<< Welcome to the Access Point >>>>> ~ # cert_cap=0