=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2017.07.06 09:31:16 =~=~=~=~=~=~=~=~=~=~=~= APBoot 1.5.5.5 (build 55373) Built: 2016-06-09 at 11:36:40 Model: AP-32x DRAM: 491 MB SF: Detected MX25U3235F with page size 64 kB, total 4 MB Flash: 4 MB NAND: 132 MiB PCIE0: link up PCIE1: link up dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 00 00 168c 0040 00002 00 00000004 00000000 00000000 00000000 dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 00 00 168c 0040 00002 00 00000004 00000000 00000000 00000000 Power: 802.3af POE In: serial Out: serial Err: serial Net: eth0, eth1 Radio: qca9990#0, qca9990#1 Reset: cold FIPS: passed Hit to stop autoboot: 2  1  0 Booting OS partition 0 Checking image @ 0x0 Copying image from 0x44000000 Image is signed; verifying checksum... passed Signer Cert OK Policy Cert OK RSA signature verified. [ 0.000000] [ 0.000000] Aruba Networks [ 0.000000] ArubaOS Version 6.4.4.11 (build 57673 / label #57673) [ 0.000000] Built by p4build@chios on 2016-12-08 at 11:21:34 PST (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) [ 0.000000] CPU: ARMv7 Processor [512f04d0] revision 0 (ARMv7), cr=10c5387d [ 0.000000] CPU: PIPT / VIPT nonaliasing data cache, PIPT instruction cache [ 0.000000] Machine: IPQ806X wave-2 board [ 0.000000] Flash variant: default [ 0.000000] msm_reserve_memory: 0x44600000, 0x200000 [ 0.000000] Memory policy: ECC disabled, Data cache writealloc [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 123178 [ 0.075663] CPU1: Booted secondary processor [ 0.091658] AXI: msm_bus_fabric_init_driver(): msm_bus_fabric_init_driver [ 0.102436] clk_tbl_nss - loaded [ 0.212496] PCI: enabling device 0000:02:00.0 (0140 -> 0143) [ 0.212683] PCI: enabling device 0000:00:00.0 (0140 -> 0143) [ 2.927428] get_bootconfig_partition: no dual boot info in shared memory [ 4.599875] m25p80 spi5.0: found mx25u3235f, expected s25fl512s [ 7.093533] Found AT97SC3203 on i2c-gpio0 [ 7.147079] no pmic restart interrupt specified [ 7.787097] [ 7.787097] Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT [ 7.866291] Starting Kernel HMAC-SHA1 KAT ...Starting Kernel DES KAT ...Completed Kernel DES KAT [ 7.972633] Starting Kernel AES KAT ...Completed Kernel AES KAT [ 8.016338] [ 8.062168] Completed Kernel HMAC-SHA1 KAT [ 8.112152] Starting Kernel AESGCM KAT ...Completed Kernel AESGCM KAT AP-type has_ble_support: ONBOARD. Domain Name: arubanetworks.com No panic info available Writing /dev/ttyHSL2 into /tmp/ble_port Enabling ble_daemon via nanny [ 11.348547] nss_driver - Turbo Support 1 [ 11.388003] nss_driver - fw of size 186944 bytes copied to load addr: 40800000, nss_id : 1 Ethernet port 1 mode: active-standby [ 12.908341] bonding: Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011) [ 12.986910] bonding: MII link monitoring set to 400 ms [ 13.059075] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 13.120930] ADDRCONF(NETDEV_UP): bond0: link is not ready [ 13.188722] bonding: bond0: enslaving eth0 as a backup interface with a down link. [ 13.313839] bonding: bond0: enslaving eth1 as a backup interface with a down link. [ 13.424804] drvlog_mod: module license 'Proprietary' taints kernel. [ 13.487378] Disabling lock debugging due to kernel taint [ 13.577475] AP xml model 89, num_radios 2 (jiffies 6786) [ 13.628616] init_asap_mod: installation:1 [ 13.676507] radio 0: band 1 ant 0 max_ssid 16 [ 13.728553] radio 1: band 0 ant 0 max_ssid 16 [ 13.780756] ethernet_device_event: dev eth0 is up Starting watchdog process... Starting update SBL2 ... SBL2 was updated already Done. [ 16.684817] Kernel watchdog refresh ended on core 0. Getting an IP address... [ 17.266979] Kernel watchdog refresh ended on core 1. [ 17.340799] eth0: 1000Mbps FullDuplex [ 17.550796] bonding: bond0: link status definitely up for interface eth0, 1000 Mbps full duplex. [ 17.645641] bonding: bond0: making interface eth0 the new active one. [ 17.722805] bonding: bond0: first active interface up! [ 17.784223] ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready [ 18.122836] eth1: 1000Mbps FullDuplex [ 18.182817] bonding: bond0: link status definitely up for interface eth1, 1000 Mbps full duplex. [ 18.382817] Settng Jumbo MRU 2000 [ 19.164792] Settng Jumbo MRU 2000 10.163.129.38 255.255.255.0 10.163.129.1 Running ADP...Done. Master is 10.100.100.100 [ 21.459418] ath_hal: 0.9.17.1 (AR5416, AR9380, WRITE_EEPROM, 11D) [ 21.527491] ath_rate_atheros: Copyright (c) 2001-2005 Atheros Communications, Inc, All Rights Reserved [ 21.638894] ath_dfs: Version 2.0.0 [ 21.638894] Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved [ 21.781599] ath_dev: Copyright (c) 2001-2007 Atheros Communications, Inc, All Rights Reserved [ 21.892314] ath_pci: (Atheros/multi-bss) [ 21.927866] PCI: enabling device 0000:01:00.0 (0140 -> 0142) [ 21.995782] ath_pci 0000:01:00.0: ath DEBUG: sc=0xc0812600 [ 32.468447] ol_txrx_pdev_attach: 1424 tx desc's allocated ; range starts from db670000 [ 32.551827] wmi_service_ready_event_rx: WMI UNIFIED SERVICE READY event [ 32.703280] wmi_ready_event_rx: WMI UNIFIED READY event [ 32.755482] target uses HTT version 2.1; host uses 2.1 [ 32.838456] ol_ath_smart_ant_attach: Firmware doest not support Smart Antenna. [ 32.912496] ol_ath_smart_ant_attach: Hardware doest not support Smart Antenna. [ 33.001624] wifi0: Base BSSID a8:bd:27:27:27:b0, 16 available BSSID(s) processor ID: 0 [ 33.093751] eth0 address=a8:bd:27:ca:72:7a [ 33.142705] br0 address=a8:bd:27:ca:72:7a [ 33.190627] wifi0: AP type AP-325, radio 0, max_bssids 16 [ 33.358106] Init the PCAP for radio0 offload 1. [ 33.400218] PCI: enabling device 0000:03:00.0 (0140 -> 0142) [ 33.468009] ath_pci 0000:03:00.0: ath DEBUG: sc=0xdd77a000 [ 43.946516] ol_txrx_pdev_attach: 1424 tx desc's allocated ; range starts from d6e90000 [ 44.029990] wmi_service_ready_event_rx: WMI UNIFIED SERVICE READY event [ 44.183567] wmi_ready_event_rx: WMI UNIFIED READY event [ 44.235770] target uses HTT version 2.1; host uses 2.1 [ 44.241830] ol_ath_smart_ant_attach: Firmware doest not support Smart Antenna. [ 44.241830] ol_ath_smart_ant_attach: Hardware doest not support Smart Antenna. [ 44.243455] wifi1: Base BSSID a8:bd:27:27:27:a0, 16 available BSSID(s) processor ID: 0 [ 44.243455] eth0 address=a8:bd:27:ca:72:7a [ 44.243486] br0 address=a8:bd:27:ca:72:7a [ 44.243486] wifi1: AP type AP-325, radio 1, max_bssids 16 [ 44.243798] Init the PCAP for radio1 offload 1. [ 44.252108] Initializing Pktlogs for 11ac [ 44.252139] Initializing Pktlogs for 11ac AP rebooted caused by cold HW reset(power loss) shutting down watchdog process (nanny will restart it)... <<<<< Welcome to the Access Point >>>>> password: [ 47.448828] Kernel watchdog refresh ended on core 1. [ 47.453795] Kernel watchdog refresh ended on core 0. input passwd is not correct! password: