APBoot 1.2.4.4 (build 26618) Built: 2011-01-07 at 13:42:04 Model: AP-10x CPU: AR7161 revision: A2 Clock: 680 MHz, DDR clock: 340 MHz, Bus clock: 170 MHz DRAM: . 128 MB POST1: mem 0 mem 1 mem 2 mem 3 passed Copy: ....    done Flash: 16 MB PCI: scanning bus 0 ... dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 00 00 168c 0029 00002 01 10000000 00000000 00000000 00000000 01 00 168c 0029 00002 01 10010000 00000000 00000000 00000000 Net: eth0 Radio: ar922x#0, ar922x#1 Hit to stop autoboot: 2  1  0 Checking image @ 0xbf100000 Image is signed; verifying checksum... passed Signer Cert OK Policy Cert OK RSA signature verified. ELF file is 32 bit Loading .text @ 0x80e00000 (3762024 bytes) Loading .data @ 0x81196770 (32 bytes) Clearing .bss @ 0x81196790 (16 bytes) ## Starting application at 0x80e00000 ... Uncompressing................................... ú Aruba Networks ArubaOS Version 6.1.3.3 (build 34156 / label #34156) Built by p4build@corsica on 2012-06-20 at 08:56:44 PDT (gcc version 4.3.3) CPU Rev: aa 71x CPU Flash variant: default Cache parity protection disabled Using 340.000 MHz high precision timer. cycles_per_jiffy=680000 Memory: 122880k/131072k available (1850k kernel code, 8080k reserved, 681k data, 2944k init, 0k highmem) available. detected lzma initramfs initramfs: LZMA lc=3,lp=0,pb=2,dictSize=8388608,origSize=12282368 LZMA initramfs by Ming-Ching Tiew ............................................................................................................................................................................................ AR7100 GPIOC major 0 wdt: registered with refresh Enabling Watchdog Talisker RSSI LED initialization Creating 1 MTD partitions on "ar7100-nor0": 0x00000000-0x01000000 : "flash" i2c /dev entries driver i2c-talisker: using default base 0x18040000 AD7416 driver probing for devices on AR7100 I2C .<6>lo: Disabled Privacy Extensions IPv6 over IPv4 tunneling driver Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT Starting Kernel HMAC-SHA1 KAT ...Completed Kernel HMAC-SHA1 KAT Starting Kernel DES KAT ...Completed Kernel DES KAT Starting Kernel AES KAT ...Completed Kernel AES KAT Domain Name: arubanetworks.com No panic info available Testing TPM... Passed ag7100_mod: module license 'unspecified' taints kernel. AG7100: Length per segment 512 AG7100: Max segments per packet 4 AG7100: Max tx descriptor count 400 AG7100: Max rx descriptor count 252 AG7100: fifo cfg 3 018001ff AG7100CHH: Mac address for unit 0 AG7100CHH: d8:c7:c8:ce:88:d1 ATHRF1: Port 0, Neg Success ATHRF1: unit 0 phy addr 0 ATHRF1: reg0 0 AP xml model 39, num_radios 2 (jiffies 4134) init_asap_mod: installation:0 radio 0: band 1 ant 0 max_ssid 8 radio 1: band 0 ant 0 max_ssid 8 setting bond0 as bridge child setting gre0 as split child Starting watchdog process... Getting an IP address... ag7100_ring_alloc Allocated 4800 at 0x81394000 ag7100_ring_alloc Allocated 3024 at 0x81385000 AG7100: cfg1 0xf cfg2 0x7014 ATHRF1: Port 0, Neg Success ATHRF1: unit 0 phy addr 0 ATHRF1: reg0 3100 AG7100: unit 0: phy not up carrier 1 Writing 4 ADDRCONF(NETDEV_UP): bond0: link is not ready AG7100: unit 0 phy is up...RGMii 100Mbps full duplex AG7100: pll reg 0x18050010: 0x1099 AG7100: cfg_1: 0x1ff0000 AG7100: cfg_2: 0x3ff AG7100: cfg_3: 0x18001ff AG7100: cfg_4: 0xffff AG7100: cfg_5: 0x7ffef AG7100: done cfg2 0x7115 ifctl 0x10000 miictrl 0x12 ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready 10.33.61.9 255.255.255.0 10.33.61.254 Running ADP...Done. Master is 10.10.61.62 ath_hal: 0.9.17.1 (AR5416, AR9380, REGOPS_FUNC, PRIVATE_DIAG, WRITE_EEPROM, 11D) ath_rate_atheros: Copyright (c) 2001-2005 Atheros Communications, Inc, All Rights Reserved ath_rate_atheros: Aruba Networks Rate Control Algorithm ath_dfs: Version 2.0.0 Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved ath_spectrum: Version 2.0.0 Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved ath_dev: Copyright (c) 2001-2007 Atheros Communications, Inc, All Rights Reserved ath_pci: 0.9.4.5 (Atheros/multi-bss) wifi0: Base BSSID d8:c7:c8:68:8d:18, 8 available BSSID(s) bond0 address=d8:c7:c8:ce:88:d1 br0 address=d8:c7:c8:ce:88:d1 wifi0: AP type AP-105, radio 0, max_bssids 8 wifi0: Atheros 9280: mem=0x10010000, irq=49 hw_base=0xb0010000 wifi1: Base BSSID d8:c7:c8:68:8d:10, 8 available BSSID(s) bond0 address=d8:c7:c8:ce:88:d1 br0 address=d8:c7:c8:ce:88:d1 wifi1: AP type AP-105, radio 1, max_bssids 8 wifi1: Atheros 9280: mem=0x10000000, irq=48 hw_base=0xb0000000 Starting FIPS KAT ... Completed FIPS KAT shutting down watchdog process (nanny will restart it)... <<<<< Welcome to the Access Point >>>>> ~ # cert_cap=0 ~ # ping 10.33.61.254 PING 10.33.61.254 (10.33.61.254): 56 data bytes 64 bytes from 10.33.61.254: icmp_seq=0 ttl=255 time=0.6 ms 64 bytes from 10.33.61.254: icmp_seq=1 ttl=255 time=0.6 ms 64 bytes from 10.33.61.254: icmp_seq=2 ttl=255 time=0.6 ms 64 bytes from 10.33.61.254: icmp_seq=3 ttl=255 time=0.6 ms 64 bytes from 10.33.61.254: icmp_seq=4 ttl=255 time=0.5 ms --- 10.33.61.254 ping statistics --- 5 packets transmitted, 5 packets received, 0% packet loss round-trip min/avg/max = 0.5/0.5/0.6 ms ~ # ~ # ping 10.33.61.254         0.61.62 PING 10.0.61.62 (10.0.61.62): 56 data bytes 64 bytes from 10.0.61.62: icmp_seq=0 ttl=62 time=0.4 ms 64 bytes from 10.0.61.62: icmp_seq=1 ttl=62 time=0.3 ms 64 bytes from 10.0.61.62: icmp_seq=2 ttl=62 time=0.3 ms 64 bytes from 10.0.61.62: icmp_seq=3 ttl=62 time=0.4 ms 64 bytes from 10.0.61.62: icmp_seq=4 ttl=62 time=0.3 ms 64 bytes from 10.0.61.62: icmp_seq=5 ttl=62 time=0.3 ms --- 10.0.61.62 ping statistics --- 6 packets transmitted, 6 packets received, 0% packet loss round-trip min/avg/max = 0.3/0.3/0.4 ms