Reply
Occasional Contributor II

AP105 reboot loop

Hi all!

I got a AP105 that is rebooting constatly.

I can't even see it from the master-controller, nor I can get in touch with it via the console-port.

I can't see any error/warning messages in the system log nor any information about it in the whitelist-db cpsec.

When i try to connect to the AP via the Console-port the following text appears:

APBoot 1.0.9.12 (build 22797)
Built: 2009-11-04 at 15:53:54

Model: AP-10x
CPU: AR7161 revision: A2
Clock: 680 MHz, DDR clock: 340 MHz, Bus clock: 170 MHz
DRAM: 128 MB
POST1: passed
Copy: done
Flash: 16 MB
PCI: scanning bus 0 ...
dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3
00 00 168c 0029 00002 01 10000000 00000000 00000000 00000000
01 00 168c 0029 00002 01 10010000 00000000 00000000 00000000
Net: eth0
Radio: ar922x#0, ar922x#1
APBoot 1.0.9.12 (build 22797)
Built: 2009-11-04 at 15:53:54

Model: AP-10x
CPU: AR7161 revision: A2
Clock: 680 MHz, DDR clock: 340 MHz, Bus clock: 170 MHz
DRAM: 128 MB
POST1: passed
Copy: done
Flash: 16 MB
PCI: scanning bus 0 ...
dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3
00 00 168c 0029 00002 01 10000000 00000000 00000000 00000000
01 00 168c 0029 00002 01 10010000 00000000 00000000 00000000
Net: eth0
Radio: ar922x#0, ar922x#1


*** Reboot caused by watchdog timeout. ***


I can't even stop the booting (the 3 sec interwall to press the enter-key).

Hardware problem?

Thanks,
Johan
Guru Elite

Re: AP105 reboot loop

Hardware problem. Please contact support so that they can RMA it.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: