Access Points

Reply
Contributor I
Posts: 40
Registered: ‎02-12-2011

Configure ap thought the controller

Hello.

I want to see the AP environment, but I cannot see it when connecting throught console. It works fine and I can see it in the controller.

Is there any way to see and modify the environment throught the controller?

Regards.
Guru Elite
Posts: 20,820
Registered: ‎03-29-2007

Re: Configure ap thought the controller

When you say environment, do you mean environment variables? All the important ones like ip address, subnet mask, default gateway, and ap-name, and ap-group can be configured through provisioning the access point in the controller under configuration> wireless> AP installation.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor I
Posts: 40
Registered: ‎02-12-2011

Re: Configure ap thought the controller

Thanks, but I would like to see: bauds, parity. data bits and stop bits. Can I see it throught the controller?

Regards.
Aruba Employee
Posts: 509
Registered: ‎07-03-2008

Re: Configure ap thought the controller

APs aren't async modems. Baud, parity, data bits and stop bits don't exist here.
Search Airheads
Showing results for 
Search instead for 
Did you mean: