Access Points

Reply
Occasional Contributor II
Posts: 32
Registered: ‎10-04-2011

New AP-105 Rebooting

The following is what I see when I start the boot sequence but can't seem to break-in to purge. Any suggestions on what to do next to try and reset?

APBoot 1.0.9.12 (build 22797)
Built: 2009-11-04 at 15:53:54

Model: AP-10x
CPU: AR7161 revision: A2
Clock: 680 MHz, DDR clock: 340 MHz, Bus clock: 170 MHz
DRAM: 128 MB
POST1: passed
Copy: done
Flash: 16 MB
PCI: scanning bus 0 ...
dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3
00 00 168c 0029 00002 01 10000000 00000000 00000000 00000000
01 00 168c 0029 00002 01 10010000 00000000 00000000 00000000
Net: eth0
Radio: ar922x#0Error: Can not enable MEM access.
, ar922x#0
*** Reboot caused by watchdog timeout. ***
MVP
Posts: 978
Registered: ‎04-13-2009

Re: New AP-105 Rebooting

That looks pretty terminal to me. I'd open a TAC case and confirm this then RMA the AP if possible.
Cheers
James

-------------------------------------------------------
-------------------@whereisjrw-------------------
------------------------blog-------------------------
ACCX #540 | ACMX #353 | ACDX #216
-----------Mobility First Expert #11----------
-------------------------------------------------------

If a reply adequately addresses your issue, please click on the "Accept as Solution" and "Give Kudos" button so this information can benefit other users via search.
Occasional Contributor II
Posts: 32
Registered: ‎10-04-2011

Re: New AP-105 Rebooting

Thank you for the reply.
Search Airheads
Showing results for 
Search instead for 
Did you mean: