Access Points

Reply
Occasional Contributor II

cascading AP-61 from ethernet port on AP-70

HI does anyone know if you can use the second ethernet port on an AP 70 to daisy chain to an AP-61 AP we are unable to run extra Cable and don't want to Mesh.

Many Thx
Guru Elite

Yes


HI does anyone know if you can use the second ethernet port on an AP 70 to daisy chain to an AP-61 AP we are unable to run extra Cable and don't want to Mesh.

Many Thx




Yes you can.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Frequent Contributor II

Config Examples wanted

ok, you response is correct to that question: that "you can do it" so: ¿Could you give us an example of the configuration? (if yes, just write it down please).

Regards.
Aruba Employee

Re: cascading AP-61 from ethernet port on AP-70

Hi Homero,

You need two things at a minimum, a wired AP profile in your AP group that enables the second port and a AAA profile that sets the initial role such that the AP can connect to the controller. Your wired AP profile might be something like:

ap wired-ap-profile "wired-ap-prof"
wired-ap-enable
switchport access vlan
trusted
!

Your AAA profile is just like any other, and if only APs are using it you could set the initial role to the AP role.

aaa profile "wired-aaa-prof"
initial-role "ap-role"
!


Then you need to set the wired AAA to be used.

aaa authentication wired
profile "wired-aaa-prof"
!


That should get you going...
-awl
Andy Logan, ACDX
Director, Strategic Account Solutions
Aruba Networks
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: