Access Points

Reply
Occasional Contributor II
Posts: 69
Registered: ‎01-11-2010

provisioning RAP2WG via zero touch

i use zero touch for provisioning the RAP2WG but i found that is error

i open port 4500 for connection from RAP3WG to the controller

but it is work if i provision via AP Installation on the controller

see at the attached file
Guru Elite
Posts: 20,761
Registered: ‎03-29-2007

Re: provisioning RAP2WG via zero touch

Can you try with another RAP2 or a RAP5 on the outside? What is the firewall?


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 69
Registered: ‎01-11-2010

Re: provisioning RAP2WG via zero touch

Firewall is Fortigate
I use Firmware 5.0.3.3 and 6.0.1.x for testing
Guru Elite
Posts: 20,761
Registered: ‎03-29-2007

Re: provisioning RAP2WG via zero touch

If it works inside, first try opening up all ports on the fortigate inbounds, just from that ip address. You should oreally only need UDP 4500 in both directions.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: