AirWave and Network Management

Reply
Occasional Contributor II
Posts: 50
Registered: ‎08-07-2009

AP load balancing

We're concerned that some of our APs are getting overworked by too many clients attached.

We're using MMS as a report engine only.

If we set a ceiling on how many clients may connect per ap, how will the APs decide which clients to allow?

Is it a smart decision (based on signal quality) or does it just deny above the limit?

We'd like to spread the clients out, but we don't want to create a situation where users are getting rejected.

Can Anyone tell what they are doing to load balance clients on APs?
Search Airheads
Showing results for 
Search instead for 
Did you mean: