AirWave and Network Management

Reply
Aruba Employee
Posts: 509
Registered: ‎07-03-2008

Uploading CSV file of switches to scan

I want to add all of my switches (about 1000) to AMP for wired-side rouge scanning. How can I add them using a CSV (or other) file? It's not practical to add them all via Device Setup -> Discover.
Aruba
Posts: 349
Registered: ‎04-14-2009

.csv upload from Deivce Setup -> Add page

There's a wizard for uploading them from a .csv on the AWMS's Device Setup -> Add page.

In our 6.4 release (eta early Nov) we are going to support scanning to add some models of Cisco switches.
Aruba Employee
Posts: 509
Registered: ‎07-03-2008

Re: Uploading CSV file of switches to scan

Ok, but those devices don't go into Device Setup -> Discover to be able to configure them for wireline scanning. What am I not getting here? Documentation is at best confusing on this.
Aruba Employee
Posts: 509
Registered: ‎07-03-2008

Re: Uploading CSV file of switches to scan

Hmmm, looks like AMP automatically scans those switches because I just got an email report on the scan results. Am I right here? If so, how often is it doing the scan of all the switches?
Aruba
Posts: 349
Registered: ‎04-14-2009

Poll period is configurable

For each Group in AWMS, you get to configure how often we poll routers/switches for arp and bridge forwarding data.
Aruba Employee
Posts: 509
Registered: ‎07-03-2008

Re: Uploading CSV file of switches to scan

Thanks Dan...I found those settings in the "Basic" tab.
Search Airheads
Showing results for 
Search instead for 
Did you mean: