01-02-2015 06:01 AM
I have Aruba 105AP's at 2 different locations, Head office running 105AP's firmware 184.108.40.206, remote office running 105AP's firmware 220.127.116.11.
Remote office required extra AP's, so I took 3 x 18.104.22.168 AP's from Head office, assumed they would pick up firmware & config from remote office controller (have since found I should have reset to defaults, but cant explain the below).
At the remote office, all AP's except the controller have fell off the network - not recognised by the controller. I have reset to default, but still no joy. I bring the switch port up and AP stays up for 2 mins and reboots, then does that continually.
Does anyone have any ideas how I resolve this?
Solved! Go to Solution.
01-02-2015 08:51 AM
you should bring the APs to the same firmware level before joining them to the instant cluster. you are working with instant APs right? there is no physical controller involved?
to get the AP acting normally i would advise to bring them online one by one in an isolated network, get the firmware on the correct level and then join them to the network with the virtual controller.
01-07-2015 08:57 AM
Thanks Boneyard, I want to try this tomorrow, but dont have a copy of the firmware I need and cant download it without a support contract!! Do you know where esle I can get firmware, or even download from my controller AP to load onto the others?
01-07-2015 10:23 AM - edited 01-07-2015 10:24 AM
There are 2 options.
Plug the IAPs that need updated into a different VLAN so they don't try and join the cluster, and then upgrade from the cloud servers or if you have a valid support contract you can download the desired code from support.arubanetworks.com. If you are set on staying on 6.2.x then you'll need a valid support contract to download older code as the cloud servers only host the newest GA release of code.
01-09-2015 05:13 AM
I had to reset & power up on a separate vlan & load firmware I had downloaded via http://<IP-address>/ArubaInstant_Orion_22.214.171.124
Then connecting to wireless vlan AP's were picked up by the controller.
Many thanks for the help.