12-04-2011 10:42 PM
Can I meet this demand in aruba Iap-93 :
I want three ssid in my IAP : "guest", "boss" and " employe"
each ssid is belong to a independent vlan , and the wireless client 's gateway is in the L3-poe-SWITCH which directly connected to the IAP.
For example: " guest " 's gateway is interface vlan 10 in L3-SWITCH , " boss " 's gateway is interface vlan 20 in L3-SWITCH
can i finish this in IAP？ or do I need to make a trunk interface in iap？
if it is nonsupport, does it means I can make 3 vlans in IAP, and set up NAT and Routing to forwarding the wireless client's packets?
thank you very much
Solved! Go to Solution.
12-05-2011 12:13 AM
Yes, you can do this.
When you define the vlan for each of the SSID, you are also defined .1Q vlans. In your example, there will be a .1Q trunk from IAP to switch.
You can also choose to use Virtual-Controller defined in which case the traffic will get Natted.
12-05-2011 12:46 AM
Does it means that , If I want to make the IAP as "Trunk Mode", I don't need to choose the VC? If I want to make the IAP as " NAT MODE" , I must to need a VC?
BTW , is the VC choosed automatically without my setting ?
12-05-2011 02:39 PM
No trunking configuration in IAP. It is enabled when you create the SSID with specific VLAN. VC election is automatic, thus it is important to configured the virtual controller IP so that you can always manage the IAP using this IP address.