12-06-2013 11:18 AM
We have several IAP 105 access points. When I setup an SSID and use virtual controller assigned addresses for the clients, I am unable to ping a handful of servers on the network, most work just fine. It does not seem to be affected by any particular security type. I have tried it on enterprise WPA, personal WPA, and open. If I turn it back to network assigned addresses it works as intended and I can ping everything.
12-06-2013 12:11 PM
Can you reach anything else when you are using the NAT option turned on?
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
12-06-2013 12:13 PM
I can reach all most everything when set to virtual controller assigned addresses.
There are only a handful of servers that I can not reach. There is one in particular that I need to be able to reach so lets start with that one.
I have turned the firewall completely off on the server and still no luck.
12-09-2013 02:50 PM
1. SSH into the VC CLI
2. Run the commands "show arp", "show datapath route", and "show datapath bridge", and save the output
3. Try pinging the servers from the VC CLI and save the result
4. Run the same commands in step #2 one more time and save the output. We can use it to compare against the before result
5. Try pinging the servers from the wireless client again and save the result
If you could send these result to us, it should give us enough information to deduce the root cause of this.