09-04-2015 12:10 PM
my customer wants an IAP use uplink to 4g network through zte mf90 modem.
what i want to know is, the value (example of value) of what i need to insert under 'cellular uplink profile' command.
i know the dial number like *99#, and other value like the ATDCGDCONT=1, but i don't know where to put those.
i also don't know if any other parameter should or should not be given any value, like the usb_tty, or puk number, or else.
i'm using rap3wn, the latest ED IAP OS Orion 220.127.116.11-4.2.
i'm also aware of mf90 type which is not listed on the supported device, but i tried it to 650 controller and it works just fine.
i believe somehow it will also work on rap3wn, and i think i'm already close. i think i just need to put the value at the right place.
thanks. i appreciate it so much if somebody helps.
ps: i'm in indonesia, the 4g isp is named BOLT SUPER 4G.
i set the country code to SG.
sent via airheads mobile.
LINE ID: ber23empat
09-08-2015 02:06 AM - edited 09-08-2015 02:12 AM
Whoa, I did not save the show running-config back there when I used the 650 controller. Now the controller no longer in my lab. But, I did save some outputs:
Thank you again.
PS: back there I used 'smartfren' card and the original 'bolt' sim card in the ZTE modem, so you might find out different successful dial number.
LINE ID: ber23empat
09-15-2015 07:59 AM
sorry for delay, I have been out of office on vacation
One odd thing is that the driver should be option, not hso and not sierra. I am a bit surprsied it came up on the sierra driver but the older sierra code is based on option so it's possible.
But, it seems for the rap3, the ZTE card is up and running, just in standby state:
(Aruba3200) #show ap debug usb ap-name rap-3wn USB Information --------------- Parameter Value --------- ----- +CSQ 31,99 ZTE, Product ZTE Serial Number Driver sierra Vendor ID 19d2 Product ID 0448 USB Modem State Standby USB Uplink RSSI(in dBm) -51 (Aruba3200) #
since the above suggests the card is ready but in standby - please confirm the rest of the config, i.e. the dial string and also what happens when you remove the ethernet and/or raise the cellular connection to a higher priority