08-05-2014 03:58 AM
I would like to know how can i change the AP225 to monitor mode by command line? Perhaps the solution could be in "dot11a-radio-profile" but i don't understand how can i use this comands.
After that I would like to know how can i restart it? is ok to use reload for restar it o maybe this comand coulb do a reset?
Thanks for all,
Solved! Go to Solution.
08-05-2014 04:16 AM - edited 08-05-2014 04:22 AM
Are you talking about spectrum monitoring? You can try using the Aruba Solution Exchange page (https://ase.arubanetworks.com/solutions/id/40). This page walks you through the CLI creation and at the end it gives you the commands with your entries where you can copy and paste it into your configuration.
About rebooting, once the configuration is done and saved, just provision the AP you want as a monitor. It will reboot itself to get the new configuration.
08-05-2014 04:39 AM
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA