Aruba Instant & Cloud Wi-Fi

Reply
New Contributor
Posts: 2
Registered: ‎11-09-2016

How do I configure a DHCP pool in Cisco router giving ip-addresses to a Instant AP VC

Do any one have an example of dhcp pool config for a Cisco router. I have Instant AP 215 connected in the network does not seem to accept my config.

They take an 169-address and do not assosiate with AIRwave.

 

ip dhcp pool IAP-Pool
 network xx.xxx.xx.48 255.255.255.240
 option 60 ascii ArubaInstantAP
 option 43 ascii TestKund:SiteLabb2,xxx.xxx.xx.xx,aruba123
 default-router xx.xxx.xx.49

 

 

Guru Elite
Posts: 20,012
Registered: ‎03-29-2007

Re: How do I configure a DHCP pool in Cisco router giving ip-addresses to a Instant AP VC

Are you sure the AP is in the same untagged VLAN as the DHCP scope? Even if the DHCP options are wrong, the ap should get an IP address... Does the AP come up without the options?
Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
Occasional Contributor I
Posts: 5
Registered: ‎05-31-2016

Re: How do I configure a DHCP pool in Cisco router giving ip-addresses to a Instant AP VC

Do you also have the vlan created on the Switch to match in with the DHCP scope. This Vlan will also need to be configured on the port that the AP is connected to. Have you tried connecting a laptop in to the same port to see if you get an IP address from DHCP.

New Contributor
Posts: 2
Registered: ‎11-09-2016

Re: How do I configure a DHCP pool in Cisco router giving ip-addresses to a Instant AP VC

Hi, problem solved !!

My misstake.

Did not have the vlan for AP propperly working over the trunk between L2 and L3 switch with the DHCP-pool on in.

 

Thanks all for your reply !!

Search Airheads
Showing results for 
Search instead for 
Did you mean: