Aruba Instant & Cloud Wi-Fi

Reply
Occasional Contributor I
Posts: 7
Registered: ‎05-25-2015

How to configure AP-105 from command line? Need to assign controller manually via CLI

Screwed up and did AP wizard from controller, but did "automatic" instead of "manual" for controller. Now, every AP not on the subnet of the controller is disconnected and rebooting over and over, with no way of connecting other than console cable.

 

The ip address is set, what cli commands will set the controller ip?

 

Any other commands I might need?

 

Thanks!

 

Guru Elite
Posts: 20,578
Registered: ‎03-29-2007

Re: How to configure AP-105 from command line? Need to assign controller manually via CLI

If you have a DNS server in your environment, setup an "a-record" that resolves "aruba-master.<domain>" to the ip address of your controller.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor I
Posts: 7
Registered: ‎05-25-2015

Re: How to configure AP-105 from command line? Need to assign controller manually via CLI

Thanks, that probably would have worked, had I statically set the domain correctly. I heard .com and it really is .coop

Stephen
Search Airheads
Showing results for 
Search instead for 
Did you mean: