Aruba Instant & Cloud Wi-Fi

Reply
Contributor I
Posts: 23
Registered: ‎11-13-2012

How to upgrade an IAP 115 using the cli

How do I upgrade system firmware using the CLI?

Aruba
Posts: 1,368
Registered: ‎12-12-2011

Re: How to upgrade an IAP 115 using the cli

Upgrading an Image Using CLI

 

To upgrade an image using a HTTP, TFTP, or FTP URL:

(Instant Access Point)# upgrade-image <ftp/tftp/http-URL>

 

To upgrade an image without rebooting the IAP:

(Instant Access Point)# upgrade-image2-no-reboot <ftp/tftp/http-URL>

 

To view the upgrade information:

(Instant Access Point)# show upgrade info

 

Seth R. Fiermonti
Consulting Systems Engineer - ACCX, ACDX, ACMX
Email: seth@hpe.com
-----
If you found my post helpful, please give kudos
Contributor I
Posts: 23
Registered: ‎11-13-2012

Re: How to upgrade an IAP 115 using the cli

Thanks Seth - this worked great!  Tftp was taking too long so I installed an Apache http server and it was able to upgrade pretty quickly after that.  The Internet connection at this location is not very good and it would fail to upgrade when using the GUI.

New Contributor
Posts: 1
Registered: ‎01-08-2015

Re: How to upgrade an IAP 115 using the cli

 Can i use the same commands for an ap225? I'm adding an ap225 to a virtual controller (ap135). 

Guru Elite
Posts: 21,007
Registered: ‎03-29-2007

Re: How to upgrade an IAP 115 using the cli

Yes.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: