Aruba Instant & Cloud Wi-Fi

Reply
New Contributor
Posts: 2
Registered: ‎04-15-2015

IAP-225 and cisco 3560G port-channel issues

I just got an Aruba IAP-225 (powered via an adapter) connected it to a Cisco 3560G switch via a 2 x 1Gb Port-channel configuration. On the Cisco side the LACP is set to active. On the AP side I see int Bond0 that is up/up and I'm able to connect via the wireless. 

 

Cisco Core Switch (IOS 15.02): 

Vlan2 - WLAN_MGNT 10.10.20.0/24

DG:10.10.20.1

Vlan10 - WLAN_MGNT 10.10.100.0/24

DG:10.10.100.1

Vlan20 - WLAN_MGNT 10.10.200.0/24

DG:10.10.200.1

Vlan25 - WLAN_MGNT 10.10.250.0/24

DG:10.10.250.1

 

Interface Po1

switchport trunk encapsulation dot1q

switchport mode trunk

switchport trunk native vlan 2

 

 

 

IAP225 (Aruba 6.3)

native vlan 2 (changed int he configs)

Bond0: 10.10.20.254

Virtual:  10.10.20.100

 

SSID

Data - Vlan 10

Voice - Vlan 20

Guest - Vlan 25

 

1. I started testing the failover feature and what I noticed is that when I disconnect eth0 port then the uplink to the switch goes down. If I unplug eth1 then the connection remains.

(Is this a known behavior?)

 

2. When the port-channel is up I see Mac address flaps on the switch.

(What is the recommended load-balancing algorithm to use?)

 

3. I'm able to ping the Virtual ip (10.10.20.100) address from the switch (10.10.20.1) but I cannot ping the physical ip (10.10.20.254) address of the AP. Is there something on the AP that I might have missed?

 

I appreciate any input regarding this setup

 

Thanks,

Andrei Patergin CCNP 

Guru Elite
Posts: 8,338
Registered: ‎09-08-2010

Re: IAP-225 and cisco 3560G port-channel issues

Which link is providing power?


Thanks,
Tim

Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
New Contributor
Posts: 2
Registered: ‎04-15-2015

Re: IAP-225 and cisco 3560G port-channel issues

I'm using the power supply (AC Adapter), no POE and no POE Injector.

 

 

Andrei Patergin (CCNP)

Search Airheads
Showing results for 
Search instead for 
Did you mean: