Aruba Instant & Cloud Wi-Fi

Reply
MVP
Posts: 371
Registered: ‎05-09-2013

IAP / AirWave stop sleep-mode

So I have a device that goes to sleep about 30 minutes after it's last use, which causes it to disconnect from the network. The device can be used without accessing the internet, so if it doesn't utilize wireless it will go into sleep mode anyway.

 

So my question is this: Is there a way to have the IAP or airwave send a ping or any traffic to the device in order to keep it from going into sleep mode. We have been successful in keeping the device on the network by sending a constant ping, but we can't continue to do this every day. Can we setup the device as a network device in airwave? It is stationary and never moves. It only operates on 2.4Ghz.

 

Thanks for the input!


Michael Haring | Senior Network Engineer
Comm Solutions, an Optiv Security Company
www.commsolutions.com | www.optiv.com
MVP
Posts: 1,422
Registered: ‎10-25-2011

Re: IAP / AirWave stop sleep-mode

Does the device support SNMP? If so, then you can add it as a Universal Network Device.
All you would need is the IP address (hopefully it is a static address) and SNMP community string.
Associate it to a group with a polling time set to 5 or 10 min.

Assuming SNMP is supported, make sure Airwave can SNMPWALK the device and ping it.

Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACMP
[If you found my post helpful, please give kudos!]
Search Airheads
Showing results for 
Search instead for 
Did you mean: