04-24-2016 07:34 AM
I would like to set up a roaming environment using these equipments.
When I watch the video of the part of roaming in the Instant training,
it have mentioned that we can add the secondary IAP to the virtual controller.
However, is it possible that I can set up roaming without the virtual controller?
cause I would like to set up the IAPs with IP assigned from the network instead of the Virtual Contoller.
It means that I would not have a virtual controller right?
04-24-2016 10:07 AM
Life off the wire
04-25-2016 03:19 AM
If you have IAPs that are in the same subnet, roaming is automatic if they are broadcasting the same SSID.
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base
Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
04-25-2016 05:46 AM
Sent from Outlook for iPhone
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
04-26-2016 01:59 AM
I have a router connected to my desktop, having the internet connection and IP 192.168.0.1
Should I connect the switch to the router for internet connection?
So what should the IP address set for the switch? 192.168.0.100?
Sorry for asking stupid question but I am a newbie to setting up such network.
04-26-2016 07:28 AM
I have drafted the diagram on how to connect everything.
The subnet is 255.255.255.0
Will the router assign a IP sddress to the switch or I can assign an IP address of 192.168.0.0/16 to the switch?
I would like to use network assigned IP address for the two IAPs.
04-27-2016 11:50 PM
the IP address is 192.168.0.1. Is that I could set the switch in the IP range 192.168.0.0/16 also,
and this could provide Internet service to the IAPs?