Aruba Instant & Cloud Wi-Fi

Reply
New Contributor
Posts: 3
Registered: ‎05-12-2016

Iap-225 wired port stays down

Hello,

 

I have a Iap-225 with software version 6.4.4.4-4.2.3.2_54910. I run this version because i wanted to disable the broadcast of the SSID's on specific times.

 

Im trying to set up my ENET1 port as a bridge port. But when i plug in my laptop on this port it stays down. If i reboot the IAP i can see the port goes up for a short time and then goes down again.

 

My setup:

So i created a new wired profile (bridge) with the following settings:

Employee

POE: Disabled

Admin status: UP

 

Under advanced settings:

Content filter disable

Uplink Disabled (tested also with enabled)

 

On the VLAN page i use Access port.

I tryed both options: virtual controller managed as network assigned

 

Security tap is default and access tab is unrestricted.

 

Now this profile is created i bind it to interface 0/1.

 

I have not tested it with another software version yet. Any Idea?

 

 

When i do a show wired-port-settings:

 

Wired Port Profiles
-------------------
Name                        VLAN Mode  Allowed VLANs  Native VLAN  Admin Status  Role                        Speed  Duplex  POE  In Use  Authentication Method  STP
----                        ---------  -------------  -----------  ------------  ----                        -----  ------  ---  ------  ---------------------  ---
wired-instant               Access     all            guest        Up            wired-instant               auto   auto    No   Yes     None                   No
default_wired_port_profile  Trunk      all            1            Down          default_wired_port_profile  auto   full    No   Yes     None                   No
bridge                      Access     all            guest        Up            bridge                      auto   auto    No   Yes     None                   No
Port Profile Assignments
------------------------
Port  Profile Name
----  ------------
0     default_wired_port_profile
1     bridge
2     wired-instant
3     wired-instant
4     wired-instant

 

Guru Elite
Posts: 20,426
Registered: ‎03-29-2007

Re: Iap-225 wired port stays down

Are you using high-powered POE to power your AP-225?  If not, it will bring the second interface down.  Check the "show tech-support" to see if that is what is happening:

 

Power Status
------------
Operational State          POE-AF: One Ethernet port disabled; USB port disabled; 1x3 chain for 2.4GHz; 3x3 chain for 5GHz
-----------------          -----------------------------------------------------------------------------------------------
Current HW State           POE-AF: One Ethernet port disabled; USB port disabled; 1x3 chain for 2.4GHz; 3x3 chain for 5GHz
LLDP Negotiated POE Power  13.0W

 

 

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

New Contributor
Posts: 3
Registered: ‎05-12-2016

Re: Iap-225 wired port stays down

Thats it. Problem solved. Thank you!

 

Operational State          POE-AF: One Ethernet port disabled; USB port disabled; 1x3 chain for 2.4GHz; 3x3 chain for 5GHz

 

Search Airheads
Showing results for 
Search instead for 
Did you mean: