Aruba Instant & Cloud Wi-Fi

Reply
Occasional Contributor II
Posts: 11
Registered: ‎12-11-2014

View PER (error-rate threshold) IAP

How do I view PER on an IAP?

 

One of the ways ARM on IAP decides to change a channel is based on Error-Rate threshold, which I believe is a fancy term for Packet Error Rate (PER). I believe it is:

> 50% PER over a 30-second period = channel change.

 

What I've been doing thus far:

# show ap debug radio-stats 0 | include "Rx Bad Fram|Rx Frames R"
...wait for 30 seconds. Issue same command.

Subtract 1st "Bad Frames" from 2nd = Total Bad Frames

Subtract 1st "Frames Recieved" from 2nd = Total Frames Recieved

PER % = Total  “Bad Frames” / Total “Frames Received”

 

Guru Elite
Posts: 19,945
Registered: ‎03-29-2007

Re: View PER (error-rate threshold) IAP

MikeA,

 

That parameter on the controller does not have an equivalent in IAP.

Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
Occasional Contributor II
Posts: 11
Registered: ‎12-11-2014

Re: View PER (error-rate threshold) IAP

The commands mentioned are on an IAP.

Are you saying there is no way, other than the above commands, to view PER on IAP?

 

Search Airheads
Showing results for 
Search instead for 
Did you mean: