Aruba Instant & Cloud Wi-Fi

Reply
New Contributor
Posts: 4
Registered: ‎02-10-2015

creation of a trunk link between the IAP and a switch

Hi All,

 

My IAP is connected to a switch, then I want to spend my different vlans created on the IAP through this link. I can create a trunk on my switch but I do not know how to do at the IAP.

Thank for your help

MVP
Posts: 1,389
Registered: ‎05-28-2008

Re: creation of a trunk link between the IAP and a switch

[ Edited ]

read here:

http://www.arubanetworks.com/techdocs/Instant_41_Mobile/Advanced/Content/UG_files/CaptivePortal/ConfWiredGuest.htm

 

http://www.arubanetworks.com/techdocs/Instant_41_Mobile/Advanced/Content/CLI_commands/wired-port-profile.htm

 

Just for you to know:

  • By default IAP consider native vlan as 1 and consider the wireless users traffic from vlan 1 as untagged.

 

  • Ethernet 0 on an AP is always in trunk mode, so there is nothing you need to do on the AP config.  Your switch port can be trunk or acces.  If it is trunk mode, set the native (untagged) VLAN to the VLAN where you want the AP to get it's IP address from.

 

  • If you are using Ethernet 1 (on a dual Ethernet AP), you have to manually set it to trunk mode using the wired port profile.

 

*****************2Plus Wireless Solutions****************************
Aruba Airheads - Powered By community for empower the community
************ Don't Forget to Kudos + me,If i helped you******************
Valued Contributor II
Posts: 804
Registered: ‎12-01-2014

Re: creation of a trunk link between the IAP and a switch

Hi Friend,

 

Here are the steps to configure Trunk in IAP,

Step 1 : Create a new Wired profile with trunkIAP_Wport1.JPG

IAP_Wport2.JPG

IAP_Wport3.JPG

 

Step 2 : map the newly created profile to the desired port,

 

IAP_Wport4.JPG

 Hope you got your answer,

 

Please free for any further help on this.

 

Cheers,
Venu Puduchery,
[Is my post helped you ? Give Kudos :) ]
Search Airheads
Showing results for 
Search instead for 
Did you mean: