ArubaOS and Controllers

Reply
Frequent Contributor II
Posts: 141
Registered: ‎08-08-2007

Allowing extra channels to be used for ARM

Firmware 5.0.3.2, going into the Regulatory Domain, I see only 1, 6 and 11 ticked on 11g, ok so far. I want to try and free up an extra 2 channels but it won't allow me to save the change. The domain is GB. Any ideas?? :confused:
Guru Elite
Posts: 20,348
Registered: ‎03-29-2007

Re: Allowing extra channels to be used for ARM

Before you click "apply" on that page, click "show commands and see the commandline equivalent" Try to paste the commandline equivalent into the commandline instead and see if there might be an error when you do. If you do, please open a support case. You should be able to enable those channels in GB


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Frequent Contributor II
Posts: 141
Registered: ‎08-08-2007

Re: Allowing extra channels to be used for ARM

Glitch in the GUI, I selected show commands, none was shown but I was able to apply the changes!
Guru Elite
Posts: 20,348
Registered: ‎03-29-2007

Re: Allowing extra channels to be used for ARM

Please file a bug with support if you can replicate this reliably....


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: