ArubaOS and Controllers

Reply
Occasional Contributor II
Posts: 69
Registered: ‎01-11-2010

Bridge Mode for 802.1x Authentication

Dear ALL,

Help me please about authentiation with 802.1x but the AP is birdge mode

Questions

Can i use bridge mode for authentication with 802.1x ?

and client can get ip address from branch (the branch have DHCP Server already)

and if it support How i will configure ? please advise me step by step
Guru Elite
Posts: 20,596
Registered: ‎03-29-2007

Re: Bridge Mode for 802.1x Authentication

1. Change Control Plane Security to enabled in Configuration> Network> Controller> Control Plane Security (all access points will reboot, so do this during a change window)
2. Make sure Auto Cert Provisioning is on.
3. Change the Forwarding Mode of the Virtual AP to Bridged


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 69
Registered: ‎01-11-2010

Re: Bridge Mode for 802.1x Authentication

Hi Cjoseph,

thank you very much for your helping

now bridge mode is work for 802.1x authentication
Search Airheads
Showing results for 
Search instead for 
Did you mean: