ArubaOS and Controllers

Reply
MVP
Posts: 369
Registered: ‎01-14-2010

CLI command to verify Ethernet connectivity

All,

I'm having a hard time finding a CLI command. How would you go about seeing wired interface stats on a campus AP or a RAP? I'd like to verify that our campus APs (AP-125s) and RAPs (RAP-5WN) are using the properly configured Ethernet ports.

Thanks!

-Mike
Guru Elite
Posts: 20,773
Registered: ‎03-29-2007

Re: CLI command to verify Ethernet connectivity

http://airheads.arubanetworks.com/vBulletin/showthread.php?t=761


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

MVP
Posts: 369
Registered: ‎01-14-2010

Re: CLI command to verify Ethernet connectivity

Colin,

As always, thanks for the spot-on help! Here's what I found for the RAP5:

Ethernet Duplex/Speed Settings
------------------------------
Autoneg Speed (Mbps) Duplex Iface
------- ------------ ------ -----
on 1000 Full eth0
on 10 Half eth1
on 100 Full eth2
on 100 Full eth3
on 10 Half eth4

Running the following will bring you right there:

show ap debug system-status ap-name | begin Autoneg

Any connected device should be associating at 100/Full, so this is a quick way to verify connectivity.

Thanks!

-Mike
Guru Elite
Posts: 20,773
Registered: ‎03-29-2007

Re: CLI command to verify Ethernet connectivity

Airwave also can display this information quite nicely:



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: