ArubaOS and Controllers

Reply
Regular Contributor I
Posts: 190
Registered: ‎04-27-2009

IKE Module Busy , how to manually stop / kill process

hi there,

dont wanna loose my running config, at the moment im stuck in "IKE MODULE BUSY", cant save the config -> startup config

any hidden command? controller is "local" at the moment , running OS 5.0.2.1 , MC 3400

regards
Guru Elite
Posts: 20,442
Registered: ‎03-29-2007

Re: IKE Module Busy , how to manually stop / kill process

If this is a local, please ensure that it has contact with the master to avoid seeing that message. In a local controller, very little of the global config can be configured with the local; most of it is derived from synching with the master. You should reload the controller and see if that message goes away, OR ensure you have ip connectivity with the master.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Regular Contributor I
Posts: 190
Registered: ‎04-27-2009

Re: IKE Module Busy , how to manually stop / kill process

A command to kill the IKE process would be fine, cause while stuck in connectivity it's not possibiel to save the config e.g. after disabluing "local" controller and set back to "master" controller.

i finally found that some route in the trunk vlans wasnt set (it was a kind of demo environment) , then it finally worked.

regards
Aruba Employee
Posts: 41
Registered: ‎04-02-2007

Re: IKE Module Busy , how to manually stop / kill process

You can restart the IKE process by issuing "process restart ike".
Search Airheads
Showing results for 
Search instead for 
Did you mean: