ArubaOS and Controllers

Reply
Occasional Contributor I
Posts: 6
Registered: ‎07-14-2010

Install A Secondary Aruba 3200 Controller

Hi Guys,
I hope you doing well.
We are planning to deploy a secondary Aruba controller for our client in Europe.
Currently, there is a master controller in the US supporting local sites, and the plan is to install a secondary controller in the UK to support offices in Europe.

The objective is to build redudancy into this so that if one of the controllers is down, the AP's failover to the secondary controller.

Can you please advise on the best practices and recommendations when implementing this in the environment.

Thanks in advance!
Guru Elite
Posts: 20,812
Registered: ‎03-29-2007

Re: Install A Secondary Aruba 3200 Controller

Unfortunately, the UK controller must be completely separate from the controller in the US due to regulatory issues

Please see http://kb.arubanetworks.com/cgi-bin/arubanetworks.cfg/php/enduser/std_adp.php?p_faqid=301


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor I
Posts: 6
Registered: ‎07-14-2010

Re: Install A Secondary Aruba 3200 Controller

Thanks for the reply.
Is it possible to configure LMS redudancy for the APs at least or it has to be totally separate, Thanks again.
Aruba
Posts: 760
Registered: ‎05-31-2007

Install A Secondary Aruba 3200 Controller

APs located in US territories must terminate on US based controllers is the FCC ruling.
Occasional Contributor I
Posts: 6
Registered: ‎07-14-2010

Re: Install A Secondary Aruba 3200 Controller

Thanks for the input Guys. Much appreciated!
Search Airheads
Showing results for 
Search instead for 
Did you mean: