ArubaOS and Controllers

Reply
Occasional Contributor I
Posts: 5
Registered: ‎05-20-2011

Managment login, radius + nsp

Hello
Im trying to find where i send the attribute so that after succesfull login with ssh to the controller i dont have to type the ordinary admin password to run #enable

I used http://airheads.arubanetworks.com/vBulletin/showthread.php?t=704 this guide to set the radius stuff upp in the first place.
Guru Elite
Posts: 21,490
Registered: ‎03-29-2007

Re: Managment login, radius + nsp

From the ArubaOS 6.0 user guide:

"Bypassing the Enable Password Prompt
The bypass enable feature lets you bypass the enable password prompt and go directly to the privileged commands (config mode) after logging on to the controller. This is useful if you want to avoid changing the enable password due to company policy.
Use the enable bypass CLI command to bypass the enable prompt an go directly to the privileged commands (config mode). Use the no enable bypass CLI command to restore the enable password prompt."


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor I
Posts: 5
Registered: ‎05-20-2011

Re: Managment login, radius + nsp

thx
Search Airheads
Showing results for 
Search instead for 
Did you mean: