ArubaOS and Controllers

Reply
New Contributor
Posts: 1
Registered: ‎05-20-2011

New M3 Controller Setup

I been trying to setup a new M3 controller but for some reason every time that i either trying to save the config or do a show run it shows the following error:

Save failed: Module Authentication is busy. Please try later

I even try doing a write erase all.

Has anybody seen this.

Thank you

Vic
Guru Elite
Posts: 19,982
Registered: ‎03-29-2007

Re: New M3 Controller Setup

That normally happens when it the controller is setup as a local (pointing to a master) and it cannot connect to the master. Change it from a local to a master and reboot.
Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
Search Airheads
Showing results for 
Search instead for 
Did you mean: