04-11-2011 07:38 PM
I am pretty new to Aruba and would like to ask soemone advise on how to configure below. Thanks a lot.
- create a new Virtual Access Point profile with the following configuration details:
5GHz prefered 802.11n wireless network with spectrum load balancing (2.4 is usually more full these days and get the system to look for interference)
Use 802.1x authentication credentials for staff wireless connections
Ratification of firewall rules for captive portal access
Customisation of captive portal interface ( align the AISWA logo)
Set up separate IP pool for captive portal users and src-NAT
- populate AirPlanning information in the controller so coverage maps can be generated
- set up RAP profiles in the controller and base software upgrade the images to at least ArubaOS5
--------------------------hardware & Software----------------------------------
Wireless Controller model #: 650
Software Version: ArubaOS 188.8.131.52 (Digitally Signed - Production Build)
IP add: 10.0.0.85
AP model #: AP-105
Number of AP on the system: 6 so far ( ordered 2 more)
04-11-2011 08:34 PM
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base
Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
04-11-2011 09:13 PM
Could you let me know how to add user's logo to the captive potal?
BTW, is this the right user guide I should look at: High-Density Wireless
Networks for Auditoriums Validated Reference Design
04-11-2011 09:47 PM
I would start with the AOS 5.0 User guide.
Chapter 13, specifically, speaks to Captive Portal settings, including
Thanks. Can you provide a link for the user guide.
I can only find "High-Density Wireless
Networks for Auditoriums Validated Reference Design" guide and it's not the right one I think.