ArubaOS and Controllers

Reply
Contributor II
Posts: 54
Registered: ‎01-05-2010

Purging AP 70

Hi All,

I was trying to purge a AP 70 which was working in bridge mode in a previous RAP setup. I tried normal purging procedure with a Y-cable by breaking ap boot process and excecuted commands; Purge,save , reset .

After rebooting the AP again acting as DHCP sevrer (like in bridge mode).Please post if some one have any input on this.

-Shafi
Guru Elite
Posts: 20,586
Registered: ‎03-29-2007

Purge and Save

Mohammed,

I'm not sure it is supposed to do that. Is the AP still giving out ip addresses, even though it cannot contact the controller? In that case, do a "flash erase 0xbfc80000 0xbfc8ffff" at the apboot> prompt.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor II
Posts: 54
Registered: ‎01-05-2010

Re: Purging AP 70


Mohammed,

I'm not sure it is supposed to do that. Is the AP still giving out ip addresses, even though it cannot contact the controller? In that case, do a "flash erase 0xbfc80000 0xbfc8ffff" at the apboot> prompt.




Hi Colin,

I did the same, its purged.Thanks.
Search Airheads
Showing results for 
Search instead for 
Did you mean: