ArubaOS and Controllers

Reply
Occasional Contributor I
Posts: 9
Registered: ‎05-16-2011

Reset Controller configuration Only

Hi...

For the Aruba controller 650 OS 3.4.2, which command (or GUI) would erase the configuration only, thus returning the controller to its out of the box config, but without deleting any of the installed licenses?

Do I need to re provision APs again after resetting the config?

All help is appreciated
Guru Elite
Posts: 20,995
Registered: ‎03-29-2007

Re: Reset Controller configuration Only

write erase


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor I
Posts: 9
Registered: ‎05-16-2011

Re: Reset Controller configuration Only

thanks
New Contributor
Posts: 1
Registered: ‎01-31-2014

Re: Reset Controller configuration Only

Bonjour,

 

J'ai reçu un controleur Aruba 650 ce jour, j'ai démarré le controleur en suivant la documentation qui se trouvait dans le colis mais je n'arrive pas à m'y connecter en http, j'ai donc essayé en mode console mais je n'ai pas la possibilité de rentrer les paramètres comme indiqué dans la documentation.

 

Comment puis-je recommencer la procédure?

 

Merci pour votre aide

 

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

 

Démarrage en mode cli :

 

CPBoot 1.0.0.0 (build 23274)
Built: 2010-01-19 at 11:11:22
DDR2 DRAM running at 466Mhz
DRAM:  Total = 512 MB
POST:  Memory test: Physical 0 - 0x10000000 - quick test
       Memory test: Physical 0x10000000 - 0x20000000 - quick test
       PASS
CPU:   XLS408Lite, rev. A1 Clock: 600MHz
CPLD:  rev: 1.3
SMP:   All 8 cpus successfully started
Board: A650
POST2: OK
PCIE:  RC2x2 mode
Net:  xls_gmac0, xls_gmac1 [PRIME], xls_gmac2, xls_gmac3, xls_gmac4, xls_gmac5
NAND device: Manufacturer ID: 0x2c, Chip ID: 0xca ( NAND 256MiB 3,3V 16-bit)
Boot:  Primary bootflash partition

Hit any key to stop autoboot:  0
booting system partition 1
part offset: 3200000 part size: 3200000
### JFFS2 loading 'uImage' to 0x87000000
Scanning JFFS2 FS:   load: loaded 'uImage' to 0x87000000 (26980312 bytes)
### JFFS2 load complete: 26980312 bytes loaded to 0x87000000

Booting image...

Image is signed; verifying checksum...
passed
Signer Cert OK
Policy Cert OK
RSA signature verified.
Jumping to the application... 0x80679000
Linux command line:  run quiet console=ttyS0,9600
------------------------------------------------------------
Downloading SOS...done.
Uncompressing core image files...done.
Mounting the flash file systems...done.

Aruba Networks
ArubaOS Version 6.2.0.1 (build 36614 / label #36614)
Built by p4build@corsica.arubanetworks.com on 2012-12-25 at 08:54:56 PST (gcc ve                                                                                                 rsion 3.4.3)
Copyright (c) 2002-2012, Aruba Networks, Inc.

           <<<<<    Welcome to Aruba Networks - Aruba A650-8    >>>>>

Starting watchdog processes
Check/update Boot Image
Reboot Cause: Power Failure.
Crash information available.
SKIPPING Generating SSH Keys......0022
done.
Initializing TPM and Certificates
Performing integrity check on Ancillary partition 1...passed.
Restoring the database...done.
Starting hwMon
Reading configuration from default.cfg



Debug mode: licensemgr is taking too long to respond. Starting shell session


BusyBox v1.01 (2012.12.25-16:44+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.

/bin/sh: can't access tty; job control turned off
/tmp #
/tmp # ifconfig
eth1      Link encap:Ethernet  HWaddr 00:00:00:00:00:00
          inet6 addr: fe80::200:ff:fe00:0/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1602  Metric:1
          RX packets:16285 errors:0 dropped:0 overruns:0 frame:0
          TX packets:16288 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:1298388 (1.2 MiB)  TX bytes:21121116 (20.1 MiB)

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:1 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:100 (100.0 B)  TX bytes:100 (100.0 B)

rtgw      Link encap:Point-Point Protocol
          inet addr:127.0.0.3  P-t-P:127.0.0.3  Mask:255.255.255.255
          UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1616  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)

tsgw      Link encap:Point-Point Protocol
          inet addr:127.0.0.2  P-t-P:127.0.0.2  Mask:255.255.255.255
          UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:960  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)

Search Airheads
Showing results for 
Search instead for 
Did you mean: