ArubaOS and Controllers

Reply
Occasional Contributor II
Posts: 39
Registered: ‎07-10-2010

SPOE in MC 800|2400

I need to know how to access Console of APs connected to MC 2400/800. I am using AP 65 (lacking console port) and MC 2400. i need to access the CLI in order to purge the AP.

I recall that you can achieve it by using Telnet port 2300, but i am unable to do so.
Can any one kindly guide me....
Guru Elite
Posts: 19,982
Registered: ‎03-29-2007

Turn on Telnet SOE

Here are the steps:

1. Turn on SOE on the controller:

config t
telnet SOE

2. Telnet into the controller on port 2300, then connect to the port and slot that the AP65 will be plugged into:

telnet 2300
enter username and password
Type "connect ", where slot/port is the slot and port where the AP65 will be connected

3. Connect the AP65, and you should see the console output.
Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
Occasional Contributor II
Posts: 39
Registered: ‎07-10-2010

Re: SPOE in MC 800|2400

Yea it worked,

Thnx a lot!
Search Airheads
Showing results for 
Search instead for 
Did you mean: