ArubaOS and Controllers

Reply
Frequent Contributor I
Posts: 108
Registered: ‎09-26-2008

Unable able to login to WebUI after setting Port-channel

HI All,

I'm unable able to login to WebUI after setting Port-channel.
Before setting port-channel on the controller, the WeBUI access is normal.
However, after configuring port-channel, I'm unable to login to WebUI.

What are the settings do I need to check and set?

Pls advise.

Mike
Guru Elite
Posts: 20,366
Registered: ‎03-29-2007

make the port channel trusted

You need to make a port channel trusted. By default, when you create a port channel, it is untrusted.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Frequent Contributor I
Posts: 108
Registered: ‎09-26-2008

Re: Unable able to login to WebUI after setting Port-channel

Yup.
We made it trusted.

We could ping the ip interface.
However we are unable to log in to SSH, tftp and WebUI of the controller.

Michael
Guru Elite
Posts: 20,366
Registered: ‎03-29-2007

Details

Turn off the port channel, and see if you still have the same problem. If the only thing you did was turn on the port channel, making it trusted is normally the issue. If that doesn't work, please open a case; you could have something else going on.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 18
Registered: ‎12-04-2008

WebUI and Port Channel Configs

Don't know if this is your problem, but on our controller every time a change is made to the port channel thru the WebUI it drops the interfaces from the channel. We have to login thru CLI and add the interfaces back to the PC. Hope this helps.
Search Airheads
Showing results for 
Search instead for 
Did you mean: