ArubaOS and Controllers

Reply
Occasional Contributor II
Posts: 20
Registered: ‎07-16-2010

Whats in my 6000 Chassis?

I have around 60 6000 controllers around my organization, and would like to go through and document what each controller has in what slot. I know there can potentially be any combination of SC-I, SC-II and M3 cards as well as SFPs. After documenting, I am going to try to standardize them across the board. But I am struggling to determine what is what in the "show inventory" command. :confused:
Guru Elite
Posts: 21,556
Registered: ‎03-29-2007

"show slots"

Try "show slots":

http://airheads.arubanetworks.com/vBulletin/showthread.php?t=1722

To add, if you have Airwave, you can SSH into the commandline of it and type :

on_controllers "show slots"

It will then run that command on ALL your controllers and give you the output.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 100
Registered: ‎11-05-2009

Re: Whats in my 6000 Chassis?

That's a very useful command, but doesn't seem to be documented in the user guide.

Is there a list of commands which aren't in the user guide?

edit: I mean the AirWave command, not the controller command.
Guru Elite
Posts: 21,556
Registered: ‎03-29-2007

Command Line Interface Guide

That command is detailed in the commandline interface guide in ArubaOS 5.0 on page 1065 and in commandline interface guide ArubaOS 6.0 on page 1030. The example does not show an M3, only a 2400.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 100
Registered: ‎11-05-2009

Re: Whats in my 6000 Chassis?




Sorry, I meant the AirWave command 'on_controllers' rather than the AOS command.

Search Airheads
Showing results for 
Search instead for 
Did you mean: