ArubaOS and Controllers

Reply
Occasional Contributor II

"show user" command shows AP name as NA

Hi,

As the title suggests, sometimes when i issue the "show user" command , the AP name shows NA, can anyone explain why this is and what conditions cause it to occur?

Thanks
Guru Elite

Re: "show user" command shows AP name as NA

What version of code is this?

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Occasional Contributor II

Re: "show user" command shows AP name as NA

Hi, its on 5.0.3.2 and its a 3600
Guru Elite

Re: "show user" command shows AP name as NA

An issue just like yours has been identified in the 5.x code, but you should open a case for them to determine if it is caused by the same thing, and if it is resolved in 5.0.4.0. I would say to upgrade to 5.0.4.0 to see if it is fixed there, if you can.

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: