Campus Switching and Routing

Reply
New Contributor
Posts: 5
Registered: ‎06-14-2016

็How to config LACP on Aruba 2930F 24G 4SFP Switch (JL259A) Connect HP A5500 HI

Dear all

       i have project implement network for customers . i not sure my configure corrected. please help me to verify command.


 Aruba 2930F LACP and trunk allow vlan 10,20,30,50 native vlan 1

 #Trunk 1-2 Trk1 lacp

 #int trk1

 #untagg vlan 1

 #tagg vlan 10,20,30,50

 

 HP A5500 HI LACP and trunk allow vlan 10,20,30,50 native vlan 1

#interface Bridge-Aggregation 1
#link-aggregation mode dynamic
#quite
#interface g1/0/1
#port link-aggregation group 1
#interface g1/0/2
#port link-aggregation group 1
#quite
#interface Bridge-Aggregation 1
#port link-type trunk
#port trunk permit vlan 10,20,30,50

Aruba Employee
Posts: 35
Registered: ‎11-17-2015

Re: ็How to config LACP on Aruba 2930F 24G 4SFP Switch (JL259A) Connect HP A5500 HI

Greetings!

 

The configuration appears essentially correct for both devices, though if untagged VLAN 1 will be carrying any traffic across the link, don't forget to include it in the A5500's Bridge-Aggregation configuration:

 

port trunk permit vlan 1,10,20,30,50
port trunk pvid vlan 1

 



Matthew Fern | Technical Marketing Engineer, Campus Networking
Aruba, a Hewlett Packard Enterprise Company
New Contributor
Posts: 5
Registered: ‎06-14-2016

Re: ็How to config LACP on Aruba 2930F 24G 4SFP Switch (JL259A) Connect HP A5500 HI

Matthew Fern,

  thank you for your support. i have second question ,Please help me  design spanning tree mode for implement , i think use stp mode MSTP for solve the problem, what the best way for choise stp mode ? and excemple command guide for implement .1232444.JPG

 

 

Aruba Employee
Posts: 35
Registered: ‎11-17-2015

Re: ็How to config LACP on Aruba 2930F 24G 4SFP Switch (JL259A) Connect HP A5500 HI

[ Edited ]

My recommendation would be to follow the guidelines in Chapter 5 of the Advanced Traffic Management Guide for the 2930F, as well as the 'Configuring spanning tree protocols' section of the 5500 Layer 2 LAN Configuration Guide (page 63; MSTP section starts on page 70). Unless you have a compelling reason not to use MSTP, that would be my recommendation.

 

For the Xyzel switch, refer to the manufacturer-provided documentation for MSTP configuration, if applicable.

 



Matthew Fern | Technical Marketing Engineer, Campus Networking
Aruba, a Hewlett Packard Enterprise Company
New Contributor
Posts: 5
Registered: ‎06-14-2016

Re: ็How to config LACP on Aruba 2930F 24G 4SFP Switch (JL259A) Connect HP A5500 HI

Matthew Fern,

  thank you for good support .  if i have problem i well call your support again .

 

Search Airheads
Showing results for 
Search instead for 
Did you mean: