Campus Switching and Routing

Occasional Contributor I

2930F VSF

Hello Everyone,

I am trying to perform VRF on Aruba 2930F.
However Iam getting the following error.

VSF port failure on link 1 port 1/51: 

Peer port 52 is not VSF enabled

ST1-CMDR: VSF port 1/51 is in error state

----  Bottom of Log : Events Listed = 255  ----


Can you provide an solution for the same. Thanks in advance.

Aruba Employee

Re: 2930F VSF



What version of software are you running on each 2930F?  Also, is there an existing configuration on the switch you're trying to add to the VSF fabric?

Matthew Fern | Technical Marketing Engineer, Wired Intelligent Edge
Aruba, a Hewlett Packard Enterprise Company
Occasional Contributor I

Re: 2930F VSF

Hi Mathew,

Thanks for your response.
This is the version WC.16.04.0008
There is no existing configuration on the switches.

Haresh Niwate
Occasional Contributor I

Re: 2930F VSF

Hello everyone,

I just performed reset on the second switch using the following commands and later vsf worked as expected.


reset system configuration

Haresh Niwate


Search Airheads
Showing results for 
Search instead for 
Did you mean: