Campus Switching and Routing

Reply
Occasional Contributor I
Posts: 5
Registered: ‎03-09-2011

AP port config for Cisco switches

When hooking up an Aruba Access Point to a cisco switch what port configurations should be set on the cisco switch?

Aruba
Posts: 760
Registered: ‎05-31-2007

Re: AP port config for Cisco switches

802.3af Power Over Ethernet (PoE) = enabled :)

 

Other than that...  if the Aruba AP is in tunnel mode, then the switchport should be in standard access mode with a single VLAN.

 

If the Aruba AP is in bridge mode, then the switchport should be in standard trunk mode, with multiple VLANs corresponding to the networks to be bridged.

 

 

Search Airheads
Showing results for 
Search instead for 
Did you mean: