Campus Switching and Routing

Reply
New Contributor
Posts: 2
Registered: 3 weeks ago

Configure Interface IP on Aruba 2930F

Hi, need some help on Aruba switch as this is first time using Aruba switch.

Want to configure something like Cisco command in Aruba Switch 2030F but cant get it right...as I can only see VLAN configuration.

 

Cisco(config)#interface fastEthernet 0

Cisco(config-if)#ip address 10.199.111.41 255.255.255.0

 

Or this Aruba switch does not support Interface IP for L3 purpose?

Guru Elite
Posts: 8,329
Registered: ‎09-08-2010

Re: Configure Interface IP on Aruba 2930F

You can only add an IP address to a VLAN. A switchport is an L2 construct.

Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
New Contributor
Posts: 2
Registered: 3 weeks ago

Re: Configure Interface IP on Aruba 2930F

This is the feature in 2930F series? 

How can i find the one which allows me to define L3 interface as what Cisco switch capable of?

I have some STP bpdu issue with Cisco switch, and would think a router port configuration would eliminate this problem.

 

Guru Elite
Posts: 8,329
Registered: ‎09-08-2010

Re: Configure Interface IP on Aruba 2930F

They are switchports. You cannot directly assign an IP address.

Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Occasional Contributor II
Posts: 11
Registered: ‎04-04-2016

Re: Configure Interface IP on Aruba 2930F

Hi,

 

In ArubaOS Switch you can´t put a physical interface in route mode.

 

#You have to create an L3 vlan interface

conf t

interface vlan XX

  ip address 10.10.10.1 255.255.255.252

  exit

#Then you have to untag that vlan on the interface connected to the other device

interface 24

  untag vlan XX

exit

 

*
If it helps flease add Kudos
Aruba Employee
Posts: 34
Registered: ‎11-17-2015

Re: Configure Interface IP on Aruba 2930F

To clarify a bit on the syntax for ArubaOS-Switch: there is only one VLAN context (as opposed to the split 'VLAN' and 'VLAN interface' used by Cisco, Comware, etc); this context is used for both L3 configuration as well as assigning the VLAN to ports.

 

 

switch# configure
switch(config)# vlan 10
switch(vlan-10)# ip address 172.16.0.1/16
switch(vlan-10)# untag 1
switch(vlan-10)# tag 24
switch(vlan-10)# exit
switch(config)# 


Matthew Fern | Technical Marketing Engineer, Campus Networking
Aruba, a Hewlett Packard Enterprise Company
Search Airheads
Showing results for 
Search instead for 
Did you mean: