Campus Switching and Routing

Reply
Occasional Contributor II
Posts: 12
Registered: ‎08-31-2016

HOW to isolete ports on comware7

Hello Community!!

I need isolete traffic of diferents ports, for example I have vlan 30 with a lot of servers (physical servers and virtual servers) and they must not communicate between them.

I tryed with port isoleted but it doesnt work:

 

sys

port-isolate group 1

 

interface range gig1/0/2 to gig 1/0/24

 port-isolate enable group 1

 


I tryed with private vlan, but its a really long configuration!!

 

do you have any idea to share:)

best regard...

Occasional Contributor II
Posts: 22
Registered: ‎09-02-2015

Re: HOW to isolete ports on comware7

Are all of the servers on the same switch?
Cheers,
Frank
Life off the wire
Occasional Contributor II
Posts: 22
Registered: ‎09-02-2015

Re: HOW to isolete ports on comware7

Then port isolate should work
Cheers,
Frank
Life off the wire
Occasional Contributor II
Posts: 12
Registered: ‎08-31-2016

Re: HOW to isolete ports on comware7

Hello mrzero,

 

Is a mix, some servers are in the same IRF stack and others in second IRF stack.

 

The fact is that isoleted-port doesnt work!! the servers can ping between them :(

Aruba Employee
Posts: 11
Registered: ‎03-23-2016

Re: HOW to isolete ports on comware7

port isolation only works on the same switch, if you need this across multiple switches then isolated private-vlans is the answer to your request.

Search Airheads
Showing results for 
Search instead for 
Did you mean: