Campus Switching and Routing

Reply
kmd
Contributor I

Need help converting 3Com Baseline Switch 2928-HPWR Plus config for S1500-24P

Hi.

I have several new S1500-24P switches to configure. I have been sitting on them for a while, because I have very little experience in configuring switches, and no experience with MAS. I've tried to look for training videos to assist me in their configuration, but I can't seem to find anything. The swicthces configurations will essentially be the same.

Is there an easy way to import the 2928-HPWR Plus config (attached)?

Or if someone is bored and wants to work it for me, I'd appreciate the help. I am at a total loss.

Thank you.

Re: Need help converting 3Com Baseline Switch 2928-HPWR Plus config for S1500-24P

there were training videos at one point, anyone have a link?

kmd
Contributor I

Re: Need help converting 3Com Baseline Switch 2928-HPWR Plus config for S1500-24P

Hi Boneyard.

I reached out to the Aruba Training Team. They told me that there will be training classes this summer. I inquired about videos. They said videos will be a part of that. Not the answer I was looking for. $$

I can find Cisco videos all over the place on Youtube. But, no basic vlan and trunking videos for Aruba. Maybe I haven't looked hard enough.

Thanks!

Guru Elite

Re: Need help converting 3Com Baseline Switch 2928-HPWR Plus config for S1500-24P

This should help you get started:

 

hostname 300wLan
!
clock timezone EST -5
!
vlan 100
vlan 101
vlan 200
vlan 201
vlan 300
vlan 301
vlan 400
vlan 401
!
mgmt-user admin root
!
spanning-tree
!
interface vlan 1
ip address 10.1.10.63 255.0.0.0
!
interface-profile switching-profile "EDGE-PORT-TRUNK"
switchport-mode trunk
native-vlan 1
trunk allowed vlan 101-101,200-201,300-301,400-401
!
interface-profile poe-profile "POE-ENABLE"
enable
!
interface-group gigabitethernet "EDGE-PORTS"
apply-to 0/0/0-0/0/23
poe-profile POE-ENABLE
switching-profile EDGE-PORT-TRUNK
lldp-profile "lldp-factory-initial"
trusted port
!
interface port-channel 1
switching-profile EDGE-PORT-TRUNK
port-channel-members 0/1/0,0/1/1
!

 


Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
kmd
Contributor I

Re: Need help converting 3Com Baseline Switch 2928-HPWR Plus config for S1500-24P

Thank you very much, Tim

 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: