Campus Switching and Routing

Reply
Occasional Contributor I
Posts: 8
Registered: ‎12-24-2014

upgraded MAS s2500 from 7.3 to 7.4.0.1 and some interfaces lost vlans

config before upgrade

interface-group gigabitethernet "vlan204"
apply-to 0/0/30-0/0/47,0/1/1-1/0/11
mstp-profile "PortFast"
poe-profile "poe-factory-initial"
aaa-profile "default"
switching-profile "vlan204"
!

 

config after upgrade

interface-group gigabitethernet "vlan204"

 

mstp-profile "PortFast"
poe-profile "poe-factory-initial"
aaa-profile "default"
switching-profile "vlan204"
!

Contributor II
Posts: 57
Registered: ‎12-10-2011

Re: upgraded MAS s2500 from 7.3 to 7.4.0.1 and some interfaces lost vlans


The config you supplied seems to have 'typo'
because when I tried the exact config:

(MAS) (config) #interface-profile switching-profile "vlan204"
(MAS) (gigabitethernet "vlan204") #apply-to 0/0/30-0/0/47,0/1/1-1/0/11
Invalid value

i.e,
The last interface ID 1/0/11 --> this is invalid, I suppose you mean 1/0/1 ?

Assuming that, I tried below config on 7.3.0.0 (build-40599)

interface-group gigabitethernet "vlan204"
   apply-to 0/0/30-0/0/47,0/1/1-1/0/1
   mstp-profile "PortFast"
   poe-profile "poe-factory-initial"
   aaa-profile "default"
   switching-profile "vlan204"
!


Then, upgraded to 7.4.0.1 (build-47484).

 ==> Post upgrade, I don't see the issue.
        Meaning: same above configuration remained intact

 

Rgds,

-Vinay

Contributor II
Posts: 57
Registered: ‎12-10-2011

Re: upgraded MAS s2500 from 7.3 to 7.4.0.1 and some interfaces lost vlans

Rectifying a small copy paste error of mine in above:

 

(MAS) (config) #interface-group gigabitethernet "vlan204"
(MAS) (gigabitethernet "vlan204") #apply-to 0/0/30-0/0/47,0/1/1-1/0/11
Invalid value

 

With proper ports specified issue is not seen.

Occasional Contributor I
Posts: 8
Registered: ‎12-24-2014

Re: upgraded MAS s2500 from 7.3 to 7.4.0.1 and some interfaces lost vlans

Not a typo.  pasted from tfpt copy of run cfg of MAS.

 

I fixed by changing 0/1/1 to 1/0/0 

does 7.4.0.1 process interface ranges differently?

 

Thanks for reply

Guru Elite
Posts: 21,291
Registered: ‎03-29-2007

Re: upgraded MAS s2500 from 7.3 to 7.4.0.1 and some interfaces lost vlans

Chewbacca-jhh,

 

Please open a case with TAC, so that they can replicate with your config.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor I
Posts: 8
Registered: ‎12-24-2014

Re: upgraded MAS s2500 from 7.3 to 7.4.0.1 and some interfaces lost vlans

case #1653750

Search Airheads
Showing results for 
Search instead for 
Did you mean: