Command of the Day

Reply
Contributor I
Posts: 90
Registered: ‎08-03-2009

Airwave HA option not available

Hi,

 

We have 2 Airwave Servers (with active licenses) running AMP 5.1.1. We are not able to active the failover as the service of failover shows "disabled". Kindly advise on how to enable it and/or add a Watch AMP for failover purposes.

Your quick response will be highly appreciated.

MVP
Posts: 561
Registered: ‎11-28-2011

Re: Airwave HA option not available

If I recall correctly, the failover server actually has to run "failover" licenses (rather than standard). Then, you go to that server (once it's up) and "watch" the main server.

 

Is the second server running failover licenses? I'm not 100% that it was done this way in v5 as it's really old now. I'm sure this is correct for v7, so I would expect it is in v5.

Kudos appreciated, but I'm not hunting! (ACMX 104)
MVP
Posts: 1,408
Registered: ‎10-25-2011

Re: Airwave HA option not available

Failover licenses are required for the standby server to act as a failover
Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACMP
[If you found my post helpful, please give kudos!]
Search Airheads
Showing results for 
Search instead for 
Did you mean: