Product and Software: This article applies to Aruba AP-125 APs and ArubaOS 2.x and 3.x. The Aruba AP-12x APs can work on one of the following power profiles:
But the PowerDsine 3000 Series does not provide enough power to go for Power Profile 1, so it cannot bring up the eth1 port on AP-125. To verify that the AP is in Power Profile 2, follow these steps: 1) From the console output of the AP-125, you find the following message: "Shutting down eth1 due to insufficient POE voltage [power profile 2] " 2) From the controller, using the command show ap debug system-status ap-name 00:1a:1e:c0:02:1c | begin Power To go for Power Profile 1, you can use PowerDsine 7000 Series only.
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.