Product and Software: This article applies to the Aruba 5000, Aruba 6000, Aruba 3000, Aruba 2400, Aruba 800, and Aruba 200 Mobility Controllers and to ArubaOS 3.3.2.14.
To enable the debug on a specific access point, follow these steps:
1) Login to the controller where the access point is terminated and enter the enable mode.
2) Enter the configuration mode by entering the following command:
config t
3) Enter the following command:
logging level debugging ap-debug <ap name> process approc
4) Enter the following command:
end
5) To save the configuration, enter the following command:
write mem
To view the log, enter the following command:
show log ap-debug <number of lines>