Controller Based WLANs

How do I enable timestamp feature on the Aruba controller so that a timestamp is included in the output of each show command in the CLI indicating the date and time the command was issued?

by on ‎07-03-2014 05:00 PM

This article explains the command to enable timestamp in the output of the show commands showing the date/time when the command was issues.

 

This is a new feature included in AOS version 6.2.1.0. Any version below 6.2.1.0 does not have the timestamp feature.

 

This article applies to all the controllers running a minimum of AOS version 6.2.1.0.

 

Environment : All the sample outputs in this article are from Aruba 3200XM controller running AOS version 6.2.1.0.

 

Use the command “clock append” enable timestamps in each show command.

Once the "clock append" command is executed, we can see the timestamp in the output of "show ap database" command highlighted in yellow.

 

rtaImage (2).png

 

 

To disable timestamp:

After it  is disabled, the timestamp cannot be seen in the "show ap database" command output any further.

 

rtaImage (3).png

 

 

To verify:

 

rtaImage (4).png

Search Airheads
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.