Controller Based WLANs

How do I set the LED operation mode for AP-10x, AP-12x, and RAP-5x?

Question: How do I set the LED operation mode for AP-10x, AP-12x, and RAP-5x?

 

Product and Software: This article applies to all Aruba controllers running ArubaOS 5.0 and later and applies to AP-10x, AP-12x, and RAP-5x.

The LED operation mode for AP-10x/AP-12x/RAP-5x/AP-9x is a configurable parameter in the system profile of AP-Group. Use the following commands to set the the LED operation mode.

(config) #ap system-profile default

(AP system profile "default") #led-mode ?

normal Normal mode

off All LEDs off

(AP system profile "default") #exit

#ap-leds ap-name ?

<ap-name> Control LEDs on AP with this name

#ap-leds ap-name asd ?

blink Make LEDs blink for identification

normal Restore LEDs to their normal behavior

#show ap system-profile default

AP system profile "default"

---------------------------

Parameter Value

--------- -----

LMS IP N/A

Backup LMS IP N/A

LMS Preemption Disabled

LMS Hold-down Period 600 sec

Number of IPSEC retries 360

LED operating mode (AP-10x/AP-12x/RAP-5x only) normal

Version history
Revision #:
1 of 1
Last update:
‎07-07-2014 04:20 PM
 
Labels (1)
Contributors
Search Airheads
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.